Back your tractor
up to the implement. Position lift arms low enough to allow the EZ-HITCH to pass under the draw pins. Then bump the draw pin
with the top of the “J-HOOK”. When both draw pins are positioned against the top of the “J-HOOK” they
will also be located directly over the retainer hole in the “J-HOOK”. Now, simply raise the lift arms. The draw
pins should settle into the “J-HOOK”. Slide the retainer pin through from the back and secure it with the small
lynch pins provided.
To keep the implement from moving in the hitches it is a good idea to adjust the outside stabilizer
arms and the spreader bar so that the hitches are located against the lynch pins in the draw pin.
Removal:
Position
the implement a few inches off the ground.
Remove the lynch pin from the retainer pin, then remove the retainer pin.
Slowly
drop lift arms.
If the lift arms fail to drop from the implement adjusting the top link in and out should allow the
lift arms to free themselves and drop. If you tightened the outside stabilizer arms you may need to loosen them also.