Back your tractor up to the implement. Position lift arms low enough to allow the EZ-HITCH to pass
under the draw pins. Then bump the draw pin with the top of the “J-HOOK”. When both draw pins are positioned against
the top of the “J-HOOK” they will also be located directly over the retainer hole in the “J-HOOK”.
Now, simply raise the lift arms. The draw pins should settle into the “J-HOOK”. Slide the retainer pin through
from the back and secure it with the small lynch pins provided.
To keep the implement from moving in the hitches it
is a good idea to adjust the outside stabilizer arms and the spreader bar so that the hitches are located against the lynch
pins in the draw pin.
Removal:
Position the implement a few inches off the ground.
Remove the
lynch pin from the retainer pin, then remove the retainer pin.
Slowly drop lift arms.
If the lift arms fail to
drop from the implement adjusting the top link in and out should allow the lift arms to free themselves and drop. If you tightened
the outside stabilizer arms you may need to loosen them also.